Sending signal through a network using the SampleGrabber plug-in
First of all, please verify that the versions of the Pure Analyzer application and the SampleGrabber plugin are matching.
To find the version number in the SampleGrabber plugin, open the plugin, click on the small cogwheel button on the plugin user interface, and the version number is displayed there. The current correct version number should be V184.108.40.206205.
To find the version number in the Pure Analyzer application, simply read it at the top of the open application, in the title bar . The current correct version number should be 220.127.116.11205.
If the numbers are not matching (the last decimal should be the same, as described above), please install the latest version of the Pure Analyzer in Flux:: Center.
If you still experience problems connecting the SampleGrabber plugin and the Pure Analyzer application, please verify that both the source system where the SampleGrabber plugin is inserted, and the destination system where the Pure Analyzer application is installed, are connected over the same network and that they both have a valid network configuration.
Both systems need to be configured with an IP network, either through a DHCP server, or through manual configuration.
If there are no signs of signal in the Pure Analyzer System application after selecting one of the available SampleGrabber plugins, please check your firewall settings and verify that both the Pure Analyzer System application and your host software are authorized for any network communication, or specifically, for UDP access from port 46000 to 46064.
Sending signal through a hardware I/O direct into the Pure Analyzer System application
For further instructions, please consult the Pure Analyzer System user manual Chapter 3 (Page 18).